BSE Filter

requires amics 5 1 0 or newer the released version of amics is and can be found at amics 5 1 release notes docid\ se8jyhxszdqfpit7s1ja0 with instruction on the software installation docid\ e1faehd1k20uedqhptzlx page manuals for previous versions of the software can be found at the older amics versions docid\ d2biwe sybowhhdww0anz page to initiate a trigger based on the average bse measured for a segment the bse filter option can be used from the segment trigger settings tab to add a new filter setting click on the "plus" button in the upper left hand corner to delete a selected filter condition, click on the red "cross" in the upper left hand corner the lower bse threshold to initiate the trigger can be set on the "bse low" column the upper bse threshold to initiate the trigger can be set on the "bse high" column the status column check box will either activate or deactivate the selected filter setting the min size setting will set the lower segment size required (in microns) to initiate the trigger the step size setting sets the grid size to try to create when a trigger is initiated the ac time will set the per point dwell time, which will adjust the total counts collected per point